Wireless chargers have become popular in recent years due to the convenience they offer. However, some wireless chargers can get hot, which can affect their performance and even damage the charging device. To prevent this from happening, you can make a custom wireless charger with a cooling fan. Here’s how:
Materials Needed:
– Wireless charging pad
– USB-powered cooling fan
– Soldering iron
– Solder
– Wire stripper
– Heat shrink tubing
– Electrical tape
– Glue gun
Steps:
1. Start by disassembling the wireless charging pad. You may need to use a screwdriver or a prying tool to remove the cover.
2. Locate the charging coil inside the charging pad. This is the component that generates the electromagnetic field that charges your device.
3. Solder two wires to the positive and negative terminals of the charging coil. Be careful not to damage the coil.
4. Cut a small piece of heat shrink tubing and slide it over each wire. Use a heat gun or a lighter to shrink the tubing and insulate the wires.
5. Connect the wires to the USB-powered cooling fan. Determine which wire is positive and negative by referring to the fan’s manual or by using a multimeter.
6. Use electrical tape to secure the wires and prevent them from coming loose.
7. Place the cooling fan inside the charging pad. Make sure it is positioned in a way that allows it to blow air over the charging coil.
8. Use a glue gun to secure the cooling fan in place.
9. Reassemble the charging pad and test it by placing your device on it. The cooling fan should turn on automatically and keep the charging pad cool.
By following these steps, you can create a custom wireless charger with a cooling fan that will help prevent overheating and ensure optimal charging performance.
A wireless charger is a convenient way to charge your phone without the hassle of cords and cables. However, wireless chargers can get hot, especially if you have a phone that supports fast charging. This can be a problem because excessive heat can damage your phone’s battery over time. To solve this problem, you can make a custom wireless charger with a cooling fan. Here’s how to do it:
Materials:
– Wireless charging pad
– USB-powered cooling fan
– Glue gun
– Wire cutters
– Electrical tape
Instructions:
1. Choose a wireless charging pad that is compatible with your phone. You can find wireless charging pads online or at electronics stores. Make sure the charging pad has a flat surface for your phone to rest on.
2. Get a USB-powered cooling fan. You can find these fans online or at computer stores. The fan should be small enough to fit on the charging pad but big enough to provide adequate cooling.
3. Cut the wires of the cooling fan. You only need the red and black wires for this project. Use wire cutters to snip the other wires.
4. Strip the ends of the red and black wires using wire strippers or scissors. You should have about 1 cm of exposed wire on each end.
5. Connect the red wire of the cooling fan to the positive (+) terminal of the wireless charging pad. You can use a glue gun to secure the wire. Make sure the wire is not touching any other components on the charging pad.
6. Connect the black wire of the cooling fan to the negative (-) terminal of the wireless charging pad. Again, use a glue gun to secure the wire.
7. Use electrical tape to cover the exposed wires and prevent any short circuits.
8. Test the wireless charger with your phone to make sure it’s working. Place your phone on the charging pad and turn on the cooling fan. You should feel a breeze coming from the fan.
9. If the cooling fan is too noisy, you can replace it with a quieter fan. You can also adjust the fan speed by using a USB fan controller.
Congratulations, you’ve made a custom wireless charger with a cooling fan! This simple project can help extend the life of your phone’s battery by preventing overheating. Plus, it’s a fun DIY project that you can customize to your liking.